HYPER-glide Choose & Install

HYPER-glide™ Creeper Wheels-
The easiest gliding wheels this side of the moon!

Wheel Home

Features & Uses

Fun & Sports

E-Mail Us

PERFORMANCE CAR & TRUCK COMPONENTS

OTHER CORP. WEB SITES:
TRUCKING & SERVICE VEHICLES
&
BUNKER CORP.-GENERAL USE PRODUCTS

Shown above- large size, set of six. (Note side graphics- specific to large wheel sets.)

Shown above- small size. (Note side graphics- specific to small wheel sets.)


Automotive-Type Creepers	Seats With Casters	Many Types of Carriers

(Note- Recommended maximum weight per wheel is 125 lbs.)

Eight Sets To Choose From:

WHEEL SIZE	COLOR	QUANTITY	SET NO.	LIST PRICE *
Small- 2” / 50mm height	black	set of four (4)	#9.9169G	$32.49
Small- 2” / 50mm height	red	set of four (4)	#9.9169R	$32.49
Small- 2” / 50mm height	black	set of six (6)	#9.9170G	$48.95
Small- 2” / 50mm height	red	set of six (6)	#9.9170R	$48.95
Large- 2 3/8” / 60mm height	black	set of four (4)	#9.9171G	$35.95
Large- 2 3/8” / 60mm height	red	set of four (4)	#9.9171R	$35.95
Large- 2 3/8” / 60mm height	black	set of six (6)	#9.9172G	$52.95
Large- 2 3/8” / 60mm height	red	set of six (6)	#9.9172R	$52.95

* Your actual price may vary.

How To Identify The Correct Size For Your Device:

HYPER-glide™ wheels will fit most standard caster assemblies. Always use the largest wheels that will fit. NOTE- Recommended maximum weight allowed is 125 lbs. per wheel. Requires two 5/32” hex key wrench (not included).

Measuring the caster wheel horn (cover) from the center of the mounting hole to the nearest inside obstruction under horn: If the top (A) measurement is greater than 1”/25.4mm and the inside width (B) of the of the caster horn is approximately .839’’ to 1”- (the 2”/50mm HYPER-glide™ wheel sets will fit). If the top (A) measurement is greater than 13/16”/30mm and the inside width (B) of the of the caster horn is approximately .839’’ to 1”- (the 23/8”/60mm HYPER-glide™ wheel sets will fit). Visually inspect the caster horn to see that its holes (C) are not too large or small (.250”min.-.265”max.) to accept the supplied screws.

Tools Required:
	Either a common hack saw or cresent wrenche(s); to remove the old wheels. (This depends on the device you wish to mount the new wheels to).
	Two 5/32" hex-head wrenches.

Measure your existing caster assembly for clearance from the axle to top and width of caster horn. See "How To Identify...", at left.

All hardware is included. (Caster is not included.)

Energy Suspension ® 1131 Via Callejon, San Clemente, California 92673-6230, USA
• Phone 1(949) 361-3935 • Fax 1(949) 361-3940
• E Mail-hyperflex@energysuspension.com

Measure-

Cut or unbolt-

Mount and tighten,
and you 're done!